Using a big chief vape cartridge big chief extracts cartridge for the first time is not always intuitive. Below are some simple and clear step-by-step instructions to get you started big chief on the go quad pod how to use and prime a vape big chief thc cartridge, and to help you avoid many common beginner mistakes.
Step One: Unpackage and Prime the Vape big chief extracts cartridge To start, big chief raspberry runtz remove the cart from its packaging and take off the white rubber covers big chief on the go quad pod either end. There should be one cover big chief on the go quad pod the mouthpiece, and another at the base over the coil.
(Image: http://www.imageafter.com/image.php?image=b16architecture_exteriors012.jpg&dl=1)With these pieces removed, big chief hemp pre rolls if your cart is working correctly, big chief on the go quad pod oil should seep into the bottom of the chamber and surround the coil. This means it is ready to be primed.
Priming To prime your cart, big chief raspberry runtz inhale from the mouthpiece several times. There should be no vapor, only air, big chief weed, and big chief cannabis the cart should not be attached to a battery. Take between 5-8 „dry hits“ in this way, pulling air through the chamber and up into your mouth.
Next, rub the cart between your palms quickly to loosen the oil. If the oil remains above the chamber, simply continue both priming steps until corrected.
Users often overlook the priming process, big chief hemp pre rolls but it helps prepare the cart for use, and will help prevent clogging in the future.
Step Two: Preheating and big chief hemp pre rolls Connecting the Battery With the cart primed, the next step is to preheat it by hand or attach it to a battery and preheat the oil.
Here, big chief hemp pre rolls please be sure you are using a 510-battery that is fully charged. All 3CHI big chief vape cartridge cartridges are designed to be used with a 510-threaded battery. Improper batteries, including MOD batteries, can easily burn or otherwise damage the cartridges.
Preheating If your compatible battery does not have a preheat button, you will need to preheat by hand. This can be done by rubbing the big chief extracts cartridge between your palms, or by gently and carefully using a blowdryer to warm the oil. Set the dryer to low heat and gently move the mouth up and down the cart from a distance of approximately eight inches.